Electrolux EGG7253NOX Bedienungsanleitung PDF herunterladen (Seite 12)

with the standard UNI EN 88. For Liquid

Gas (LPG) the use of pressure regulator is

allowed only if they are in compliance with

UNI EN 12864. The adjustable connection

is fixed to the comprehensive ramp by

means of a threaded nut G 1/2". Screw

the parts without force, adjust the con-

nection in the necessary direction and

tighten everything.

ABC

A)

End of shaft with nut

B)

Washer

C)

Elbow

Rigid connection:

Carry out connection by using metal rigid

pipes (copper with mechanical end) (UNI-

CIG 7129).

Flexible connection:

Use a flexible pipe in stainless steel (UNI-

CIG 9891) with a maximum length 2 m.

When installation is complete,

make sure that the seal of each

pipe fitting is correct. Use a soapy

solution, not a flame!

8.2 Injectors replacement

1.

Remove the pan supports.

2.

Remove the caps and crowns of the

burner.

3.

With a socket spanner 7 remove the

injectors and replace them with the

ones which are necessary for the type

of gas you use (see table in "Techni-

cal Information" chapter).

4.

Assemble the parts, follow the same

procedure backwards.

5.

Replace the rating plate (it is near the

gas supply pipe) with the one for the

new type of gas supply. You can find

this plate in the package supplied

with the appliance.

If the supply gas pressure is changeable

or different from the necessary pressure,

you must fit an applicable pressure ad-

juster on the gas supply pipe.

8.3 Adjustment of minimum level

To adjust the minimum level of the burn-

ers:

1.

Light the burner.

2.

Turn the knob on the minimum posi-

tion.

3.

Remove the knob.

4.

With a thin screwdriver, adjust the by-

pass screw position.

A

A)

The by-pass screw

• If you change from natural gas G20 20

mbar to liquid gas, fully tighten the by-

pass screw in.

• If you change from liquid gas to natural

gas G20 20 mbar, undo the by-pass

screw approximately 1/4 of a turn (1/2

of a turn for Triple Crown burner).

WARNING!

Make sure the flame does not go

out when you quickly turn the

knob from the maximum position

to the minimum position.

8.4 Electrical connection

• Ground the appliance according to

safety precautions.

• Make sure that the rated voltage and

type of power on the rating plate agree

with the voltage and the power of the

local power supply.

• This appliance is supplied with a mains

cable. It has to be supply with a correct

plug, able to support the load marked

on the rating plate. The plug has to be

fitted in a correct socket.

• Any electrical component must be in-

stalled or replaced by the Service Force

12

www.electrolux.com

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 47 48

Kommentare zu diesen Handbüchern

Keine Kommentare