Electrolux TC15014 Bedienungsanleitung PDF herunterladen (Seite 10)

Problem Possible cause Solution

There is no cold air circula-

tion in the appliance.

Make sure that there is cold

air circulation in the appli-

ance.

8.2 Replacing the lamp

Disconnect the plug from the mains

socket.

1. Remove the screw from the lamp

cover.

2. Remove the lamp cover (refer to the

illustration).

3. Replace the used lamp with a new

lamp of the same power and

specifically designed for household

appliances (the maximum power is

shown on the lamp cover).

4. Install the lamp cover.

5. Tighten the screw to the lamp cover.

6. Connect the plug to the mains socket.

7. Open the door.

Make sure that the light comes on.

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective

door gaskets. Contact the Service

Center.

9. INSTALLATION

WARNING!

Refer to Safety chapters.

9.1 Positioning

This appliance can be installed in a dry,

well ventilated indoor where the ambient

temperature corresponds to the climate

class indicated on the rating plate of the

appliance:

Climate

class

Ambient temperature

SN +10°C to + 32°C

N +16°C to + 32°C

ST +16°C to + 38°C

T +16°C to + 43°C

Some functional problems

might occur for some types

of models when operating

outside of that range. The

correct operation can only be

guaranteed within the

specified temperature range.

If you have any doubts

regarding where to install the

appliance, please turn to the

vendor, to our customer

service or to the nearest

Service Centre

9.2 Rear spacers

In the bag with the documentation, there

are two spacers which must be fitted as

shown in the figure.

1. Fit the spacers into the holes. Make

sure that the arrow (A) is positioned as

shown in the picture.

www.electrolux.com10

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 59 60

Kommentare zu diesen Handbüchern

Keine Kommentare