Electrolux SC300 Bedienungsanleitung PDF herunterladen (Seite 13)

Problem Possible cause Solution

There is too much frost

and ice.

The door is not closed

correctly or the gasket is

deformed/dirty.

Refer to "Closing the door".

The compressor does not

start immediately after

pressing the COOLMATIC,

or after changing the tem‐

perature.

This is normal, no error

has occurred.

The compressor starts after

a period of time.

Water flows inside the re‐

frigerator.

The water outlet is clog‐

ged.

Clean the water outlet.

Food products prevent

that water flows into the

water collector.

Make sure that food prod‐

ucts do not touch the rear

plate.

Water flows on the floor. The melting water outlet

is not connected to the

evaporative tray above

the compressor.

Attach the melting water out‐

let to the evaporative tray.

Temperature cannot be

set.

The COOLMATIC func‐

tion is switched on.

Switch off COOLMATIC

manually, or wait until the

function resets automatically

to set the temperature. Refer

to " COOLMATIC function".

DEMO appears on the dis‐

play.

The appliance is in dem‐

onstration mode.

Keep the Mode pressed for

approximately 10 seconds

until a long sound is heard

and display shuts off for a

short time.

Door is misaligned or inter‐

feres with ventilation grill.

The appliance is not lev‐

elled.

Refer to "Levelling".

The temperature in the ap‐

pliance is too low/too high.

The temperature regula‐

tor is not set correctly.

Set a higher/lower tempera‐

ture.

The door is not closed

correctly.

Refer to "Closing the door".

Food products placed in

the appliance were too

warm.

Allow food products to cool

to room temperature before

storing.

Many food products were

put in at the same time.

Wait some hours and then

check the temperature

again.

The door has been

opened often.

Open the door only if neces‐

sary.

ENGLISH 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare