Electrolux FAC124P1A Betriebsanleitung PDF herunterladen (Seite 103)

Section 4 Component Teardown

4-43

Figure 4-111.

Screws

Front Front

Screws

Right Side

Left Side

Figure 4-112.

Cabinet Wrapper/Sleeve Removal

The cabinet wrapper/ sleeve is secured to the unit frame

with 3 screws along the lower right side, 4 screws on the

left side and 2 screws that must be extracted from the

top of the unit.

To remove the cabinet wrapper/ sleeve:

1. Disconnect power supply from unit.

2. Remove front panel. The user interface does not

have to be removed from the front panel.

3. Extract the screws from the cabinet wrapper/sleeve,

then pull the left and right bottom edges away from

the unit frame and lift the cabinet wrapper/sleeve off

the unit. (See Figure 4-111)

Control Panel Removal

The control panel is secured to the unit frame with two

retaining tabs that slide into slots along the right side of

the mounting bracket and a screw at the top and bottom

of the control panel mounting bracket.

To remove the cabinet wrapper/ sleeve:

1. Disconnect power supply from unit.

2. Remove the front panel and cabinet wrapper/sleeve.

3. Extract the screws from front of control panel

mounting bracket. (See Figure 4-112)

4. Lift the control panel assembly upwards to release

the retaining tabs then pull the control panel

assembly away from the unit frame to access the

wire leads connected to the control board.

5. Discharge capacitor.

To discharge the high voltage capacitor, wait for 60

seconds and then short-circuit the connection of the

high-voltage capacitor (that is the connecting lead of

the high-voltage rectifier) against the chassis with the

use of an insulated screwdriver.

CAUTION

6. The wire harness connector for the user interface

is glued to the control board connector. Carefully

remove glue with a sharp knife before attempting to

disconnect connector from control board.

7. Disconnect all wire leads connected to control panel.

Label wire leads as needed to identify and for the

reconnecting of wire leads.

8. Use a small pliers to compress the plastic retainers

securing the control board and remove from the

mounting bracket.

Retaining

Tabs

Screws

Figure 4-110.

Screws

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux FAC124P1A Betriebsanleitung Seite 103

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Electrolux FAC124P1A