Electrolux FAC124P1A Betriebsanleitung PDF herunterladen (Seite 47)

Section 2 Installation

2-17

Installing the Unit in a Casement Window

1. Attach support brace to platform as shown. Use

the adjustment bolt and hex flange nut to complete

the assembly. Choose the slot and adjustment bolt

hole locations that will create a 45 degree angle

between the platform and the support brace. Try the

assembly in the window to determine if the platform

will rest properly, and allow the proper slope (3/16-

inch lower on outside). (See Figure 2-50)

2. Drill a 9/64-inch diameter pilot hole in the window

jamb an equal distance from each side of the jamb,

and 3/16-inch up from the window sill. If the hole

coincides with the window lever slot in the jamb

bottom, an additional hole will have to be drilled

through the platform edge and the window jamb to

miss this slot.

3. Peel off the protective backing from the track seal,

and stick the seal to the window sill on the outside

of the bottom jamb. (See Figure 2-51)

4. Screw the platform assembly to the window jamb

through the pilot hole you drilled in Step 2. Use

a #8 x 3/4-inch self-threading screw.

(See Figure 2-52)

5. Adjust the platform assembly so that the rear of

the air conditioner will be 3/16-inch lower than the

front. This ensures proper water drainage from the

air conditioner. (See Figure 2-53)

Open the window the maximum amount to allow for

clearance of the cabinet. The crank handle should

be removed to allow the platform to be fastened to

the jamb. If the window cannot open far enough

(more than 15-1/2 inches) for the cabinet to clear the

window, remove the window entirely by drilling out the

rivets. Bolts can serve as the pivots in the future.

To avoid crank handle and window clearance problems,

the unit can be installed in a stationary sash section.

However, the horizontal mullion and the 2 glass panels

must be removed before installation.

NOTE

If you are planning to use a siding protection board on

the outside of house, hold board in place when testing

assembly in window.

NOTE

Platform Assembly

1/4" (6mm) Hex Flange Nut

Figure 2-50.

8-11/16”

Equal distance

Apply track seal to the outside

edge of the bottom window jamb.

from both sides

Screw

Track Seal

Window

Jamb

Figure 2-51.

Figure 2-52.

Rear is at least

7/16" lower

than front

Figure 2-53.

A projection below the base of the air conditioner will

require the rear of the platform to be 7/16-inch lower

than the front to create the 3/16-inch slant from front

to rear.

NOTE

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux FAC124P1A Betriebsanleitung Seite 47

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Electrolux FAC124P1A