Electrolux FAC124P1A Betriebsanleitung PDF herunterladen (Seite 92)

Section 4 Component Teardown

4-32

Accessing the Condenser Fan and Blower

Assembly and Compressor

In order to access the condenser fan and blower

assembly, the condenser and compressor must be

removed from their installation positions. Care must be

taken when moving the condenser so that the copper

tubing is not kinked or ruptured.

1. Disconnect the power supply from unit.

2. Remove front panel and cabinet wrapper/sleeve.

3. Extract the two screws at the lower rear corners

securing the condenser to the unit frame.

(See Figure 4-81)

4. Extract the three screws from each side of the

condenser securing the left and right side condenser

bracket to the condenser. (See Figure 4-81)

5. Lift the condenser upwards to clear the base tray

and rotate condenser slowly towards the right

counter clockwise until screws for the condenser

shroud are accessible.

6. Using a 16 mm socket or wrench, remove the nut

securing condenser fan blade to condenser fan

motor shaft. Remove lock washer and washer, then

pull fan blade from motor shaft. (See Figure 4-82)

7. Extract the two screws securing the condenser

shroud to the unit base. Remove shroud from unit.

8. To remove the condenser blower and fan motor,

the entire sealed system must be removed as an

assembly from the unit base. Begin by removing all

wire harness tiedowns securing the condenser fan

motor and compressor wire harness leads to the unit

partition. Carefully position condenser back onto

the unit base tray. Use care not to deform fins on

condenser with the condenser motor shaft.

9. Use a 13 mm socket or wrench and remove the

three nuts securing the compressor to the mounting

bracket. (See Figure 4-83)

10. Remove the front scroll housing adapter from above

the evaporator. Extract the two screws on each side

of the evaporator securing the mounting bracket to

the unit partition.

11. Lift the compressor off the mounting studs then

carefully move the entire sealed system to the left

until free of unit partition.

Figure 4-81.

Figure 4-82.

Condenser Screws

Condenser Bracket

Screws

16 mm Nut

Figure 4-83.

13 mm Nuts

2 of 3 shown

It is recommended to have two people remove the

sealed system from the unit base tray.

CAUTION

1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 139 140

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux FAC124P1A Betriebsanleitung Seite 92

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Split-System-Klimaanlagen Electrolux FAC124P1A