Electrolux RO400B Bedienungsanleitung PDF herunterladen (Seite 17)

MAINTENANCE

7 While the spigot is still on (open), disconnect the

electrical plug, see Fig. B. Then turn off the spigot. Now

leave the water purifier like this for about 10 hours (e.g.

over night).

8 At the end of the 10 hours, undo the container .

Discard its contents and rinse it with water.

9 Put the filter back in the container and follow steps 8–11

as described under "Replacing the filters" (except that you

put back the filter which has already been used).

10 Turn on the spigot and let the water run for 10 minutes.

Then turn off the spigot. The appliance will switch to

flushing mode for some time.

This completes the descaling procedure. The RO 400

is ready for normal use again.

Disinfection

If the water has a slight odor and the appliance has not

been used for a time (several days), there may be a build-

up of microorganisms on the membrane. If this is the

case, it is advisable to disinfect the water purifier and also

change the filters.

The disinfectant, which contains the active ingredient sodium

hypochlorite (3,5%), can be bought from supermarkets

or from the chemist. The disinfectant must be odourless.

The disinfectant must be kept out of the reach of

children. Wash your hands after using it.

1 Disconnect the electrical plug, then plug it back in again

to make the appliance switch to flushing mode.

2 Undo filter container as described under "Replacing

the filters", steps 3–7.

3 Fill the container three-quarters full of lukewarm water,

and add 1 fl oz (25 ml) of the correct disinfectant, see Fig.

C. If the concentration is not 3,5% adjust the amount of

disinfectant according to the concentration.

4 Screw the container (containing the solution) back onto

the appliance with the aid of the filter spanner.

5 Turn on the spigot for purified water and let the RO 400

operate for 45 seconds.

6 While the spigot is still on (open), disconnect the

electrical plug, see Fig. B. Then turn off the spigot and

leave the water purifier like this for about 30 minutes.

During this time, install new filters, both particle- and

carbonfilter according to "Replacing the filters".

7 Restart the RO 400 by reconnecting the electrical plug to

the wall socket, let it flush automatically.

8 Refit the front cover.

9 Work through all the steps of the full "Flushing

procedure".

The RO 400 is ready for use again.

Water containing disinfectant will be

produced. Do not drink this water.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux RO400B Bedienungsanleitung Seite 17

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Electrolux RO400B