Electrolux RO400B Bedienungsanleitung PDF herunterladen (Seite 9)

Electrical and plumbing connections

The illustration reproduced in Fig. C is also to be found

on the rear of the appliance, to show how the various

connections should be made.

The RO 400 is connected to the cold water supply 36 -

104 °F (temperature range 2 - 40 °C) via a polyethylene

feed hose (3). The cold water pipe should have a valve

easily accessible for shutting off the supply, see Fig. D. If

the appliance is being connected to new pipes or pipes

which have been out of use for some time, the water should

be allowed to run for a while before you connect the hose.

This will prevent the appliance intake filter (referred to here

as the "grid") from getting blocked by sand or rust. The

appliance has two outward water hoses. The purified water

is taken via the purified water hose (1) to a separate spigot,

while the reject water is connected directly to a waste pipe

via the reject water hose (2).

The water purifier must be connected to an earthed

electrical supply (115 V, 60 Hz). We recommend use of a

plug-in connection to a wall socket, since certain

procedures such as replacing filters and preparing the

appliance for storage if it will not be used for a time

require the power supply to be disconnected, then

reconnected. Using an electrical plug also makes it easier

to move the appliance.

To fit the spigot for purified water

Avoid cutting the hose for purified water, even if it is too

long. If it must be cut, do so with a very sharp knife,

such as a Stanley knife, making sure that the cut is

straight and clean, and that the hose is not deformed by

cutting, see Fig. E. It is important to observe these

points to ensure that the connection will be fully

watertight. Install the two hose inserts, one at each end

of the hose for purified water.

1 Mark the centre of the place where the purified water

spigot is to be installed. Make sure that there is enough

room below the worktop for the hose supplying the

spigot to be attached beneath this point.

2 Drill a 5/8” (16 mm) hole.

3 Remove the small section of protective tubing and install

the main spigot pipe on the spigot assembly.

Install the whole spigot on the worktop/sink bench as

shown in Fig. F1. The worktop or bench must be no

thicker than 1 3/8” (35 mm). Screw the quick connector

fitting onto the main thread protruding from the bottom

of the spigot assembly. Then press the end of the purified

water hose all the way home into this quick connector, as

far as the line marked on the hose 11/16” (about 17

mm), see Fig. F2.

INSTALLATION

12 3

1 3/8”

(35 mm)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux RO400B Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Electrolux RO400B