Electrolux RO400B Bedienungsanleitung PDF herunterladen (Seite 18)

To clean the grid

The grid (a coarse filter) is designed to intercept large particles and is

located inside the connection for the feed water on the appliance. If

the pattern of indicator lights on the control panel shows that the

intake pressure is too low, the reason may be that the grid is clogged.

1 Turn off the spigot for purified water. Disconnect the appliance from

the electrical supply.

2 Close the valve on the water supply pipe.

3 Undo the feed water hose connector on the back of the appliance.

4 Use suitable pliers to grip and remove the grid (Fig. A).

5 Clean the grid and run water through it before putting it back inside

the connector.

6 Reconnect the feed water hose to the appliance.

7 Open the valve on the cold water supply pipe and check that there are

no leaks.

8 Connect the appliance to the electrical supply again. It will flush

automatically.

Preparing the RO 400 for storage and

protecting it from freezing

If the RO 400 is not going to be used for a period longer than four

months, or if the purifier is going to be disconnected from water and

electricity, it needs to be filled with a special product to keep it in

good condition. The correct product ("Preservative and Antifreeze

Liquid") can be ordered from your dealer. Please quote the part

number listed under "Optional accessories and consumables".

This product must be kept out of the reach of children. Wash your

hands after using it.

1 Make sure the spigot is closed and the appliance has stopped flushing.

2 Close the valve on the water supply pipe. Disconnect the electrical plug

and the hose for feed water (but not at the appliance end). Study Fig. B.

3 Undo both filter containers as described under "Replacing the filters",

steps 3–6. Remove the two filter inserts and discard them (should

not be kept for re-use). Empty the water from the containers.

4 Put the empty filter containers back in their normal places and tighten

them. Make sure that each sealing ring is in place in the groove on the

top edge of each container.

5 Mix 1/2 gallon (2 litres) of the "Preservative and Antifreeze Liquid"

with 1 gallon (4 litres) of water in a bucket.

6 Put the end of the hose (feed water) into the mixture. Make sure

that the end of the feed water hose remains beneath the surface

throughout, see Fig. C.

7 Connect the electrical plug again. The RO 400 will now auto-

matically pump the mixture inside the appliance. After 40 seconds,

disconnect the electrical plug. Repeat this step until all the mixture has

been drown up. Leave the spigot for pure water open or disconnect

the pure water hose from appliance.

You have now prepared the RO 400 for storage. It can be left

in this state for up to nine months and down to temperatures of

-22 °F (-30 °C). Disconnect the purifier from electricity and

feed water.

When the RO 400 is to be brought back into use

you must:

• Ensure that the water purifier is kept somewhere where the

temperature is higher than 41 °F (5 °C) for at least 48 hours.

• Work through all the steps of the full "Flushing procedure",

to remove the preservative.

• Fit new filter inserts (both and ), see "Replacing the

filters".

MAINTENANCE

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Kommentare zu diesen Handbüchern

Keine Kommentare

Electrolux RO400B Bedienungsanleitung Seite 18

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Nein Electrolux RO400B